I-PAC 340

Single-phase inverter Plasma cutter.
Manual cutting can be done on any ferrous and non-ferrous materials as long as they are electrically conductive, such as copper steel, aluminum, stainless steel, and so on.
The i-PAC 340 is designed for small repair and construction jobs.

i-PAC 340 delivers 35 Amp and handles plates up to 8mm with a quality cut. If there are no special demands about the quality of the cut surface, the severance is up to 12mm.
The supply voltage is single phase at 230Volt. Thanks to its low energy consumption it can be used with reduced installed power; can be connected to a motor generator (see technical data table).
The machine needs 115 liters of compressed air per minute.

The plasma arc is ignited automatically by the pilot arc. This means longer service life of wear parts in the torch body.
Cutting on perforated plates is possible due to the advanced technology that makes the machine switch between cutting arc and pilot arc.

Equipment: DE25 torch 4m, 3 nozzles (Ø 0,8mm), Cable with ground clamp, air connection (8/10mm).